Fire & Smoke Damage Restoration in Itasca, IL

Fire damage cleanup and rebuild in Itasca

Our fire work picks up where the fire department leaves off. We remove the burned and water-soaked materials, clean soot from the surfaces that can stay and run HEPA air scrubbers through the cleanup. Smoke odor is controlled by pulling the porous materials that hold it and sealing the framing that remains. The water from the hoses gets extracted and dried with daily moisture readings, and then we rebuild.

Itasca is on our regular route, off I-290 and Route 53, with Irving Park Road and Thorndale Avenue taking us across town in DuPage County. When a fire starts inside a wall, from wiring or an outlet, the visible damage can be the least of it. We open the wall past the scorch marks until we reach clean framing, cut out or reinforce any studs that charred, and replace the wiring the fire touched. That electrical work gets permitted and inspected before the drywall goes back on.

Fire & Smoke Damage Restoration by ONIT Solutions

Inside-the-wall fire repair in Itasca

Opening the wall

We remove drywall past the scorch marks until we reach framing the fire never touched.

Charred framing repair

Studs and plates that burned get cut out or reinforced with new lumber.

Wiring the fire touched

Damaged wiring and boxes are replaced, with the permit and inspection where Itasca requires them.

Soot cleaning

We clean the surfaces around the fire so they can be primed and painted, not just covered.

Air scrubbing and odor sealing

HEPA scrubbers run during the work, and the framing that stays is sealed with an odor-blocking primer.

Closing it back up

Insulation, drywall, trim and paint are finished to match the rest of the room.

How we handle an Itasca fire repair

We see the damage in person, photograph it and write the estimate line by line in the format insurance carriers use. Since a wall fire hides most of its damage, we tell you up front that the scope may grow once the wall is open, and anything new is priced in writing for your approval first. Daily equipment rates are in writing before setup. We book the rebuild around the inspection dates and finish with a walkthrough.

Around-the-clock calls and texts at (815) 585-1750
Walls opened until we reach clean framing
Charred studs cut out or reinforced
Electrical repairs permitted and inspected
Hidden damage priced before it is fixed
Walkthrough before the job is closed

Fire & Smoke Damage Restoration estimate in Itasca

Tell us about the project and we will set a time to look at it.

FAQ

Fire & Smoke Damage Restoration in Itasca: questions

What should I do before you get there?

Wait for the fire department to clear the house, and if the fire was electrical, leave the breakers the way they set them. Do not wipe soot from walls or outlets, since that spreads it. Photograph every room and the damage up close, then call your carrier to open the claim. Text the photos to (815) 585-1750 when you can.

How do you know where the fire damage inside a wall stops?

We keep opening the wall until the framing is clean. Charring shows on the studs once the drywall is off, so we follow it until the wood is sound and the cavity smells like wood, not smoke.

Do I need a permit in Itasca for this?

Electrical repairs and new framing generally do. We pull what Itasca requires and schedule the inspections before we close the wall.

How long does a wall fire repair take?

It depends on how much of the wall and wiring the fire reached. Once the wall is open we can tell you, and the rebuild timing follows the permit and inspection dates.

Do you serve towns next to Itasca?

Yes, we also handle fire and smoke damage in Wood Dale, Roselle, Addison and Schaumburg.

Other work we do in Itasca

Nearby

Fire & Smoke Damage Restoration in Itasca