Fire & Smoke Damage Restoration in Bloomingdale, IL

When smoke reaches rooms the fire never did

A fire can burn one room and leave soot in all of them. We clear out what burned first, cutting out the damaged drywall and insulation and hauling it away. Then we clean the soot off the surfaces that can be saved, room by room, with HEPA air scrubbers running so it does not settle again. Odor is handled at the source by removing porous materials that absorbed it and sealing what stays, and the rebuild follows once the house is clean and dry.

Bloomingdale is on our regular route in DuPage County, along Lake Street, Army Trail Road, Bloomingdale Road and Gary Avenue. If your furnace fan was running during the fire, smoke likely moved through the ductwork and into bedrooms down the hall. Dark lines around the supply registers and on the ceiling near them are a sign of it. We clean the registers and the surfaces around them, and we write the duct path into the scope so your adjuster can see why rooms with no fire are on the estimate.

Fire & Smoke Damage Restoration by ONIT Solutions

Fire and smoke cleanup for a Bloomingdale house

Whole-house soot check

We check every room for soot, not just the one that burned, and photograph what we find.

Burned material tear-out

Charred drywall, insulation, flooring and trim come out and get hauled away.

Register and ceiling cleaning

Supply registers get cleaned, and the soot lines around them come off the walls and ceilings.

HEPA air scrubbing

Scrubbers keep fine soot from drifting back into rooms that have already been cleaned.

Odor removal and sealing

Porous materials that hold smoke odor come out, and what stays gets an odor-blocking primer.

Rebuild and paint

We put back the drywall, insulation, floors, trim and paint so the burned room matches the rest.

How a Bloomingdale fire claim runs with us

We photograph every room, including the ones with only light soot, because those lines belong in the scope too. The estimate is written line by line in the pricing format carriers use, and we will meet the adjuster at the house if asked. Equipment rates are on paper before we set anything up. Changes get priced and approved by you in writing, the rebuild is booked once the scope is approved, and a walkthrough closes it out.

Calls and texts taken 24/7
Soot cleaned in every room it reached
Duct path documented for the adjuster
Equipment rates on paper before setup
Burned rooms rebuilt to match the house
Photos, readings and estimate copies sent to you

Fire & Smoke Damage Restoration estimate in Bloomingdale

Tell us about the project and we will set a time to look at it.

FAQ

Fire & Smoke Damage Restoration in Bloomingdale: questions

What should I do before you get here?

Let the fire department clear the house before anyone goes inside. Leave the soot where it is, since wiping it smears it and makes the cleaning harder. If the furnace is still running, set the thermostat fan to off so it stops moving smoke. Photograph every room and call your carrier to start the claim.

Why is there soot in rooms the fire never reached?

Smoke moves with the air, through doorways, stairwells and ductwork. Rooms down the hall often get a thin film that needs cleaning even though nothing in them burned.

Does Bloomingdale need a permit for fire repairs?

Framing, electrical and plumbing in the rebuild often do. We pull what Bloomingdale requires and schedule the inspections.

How long will this take?

That depends on how much burned and how much water went in. Cleanup and drying are done when the readings and the surfaces say so, and the rebuild follows once the scope is approved. Call or text (815) 585-1750 and we can give you a clearer timeline once we see it.

What towns near Bloomingdale do you serve?

We also do fire and smoke work in Glendale Heights, Roselle, Carol Stream and Itasca.

Other work we do in Bloomingdale

Nearby

Fire & Smoke Damage Restoration in Bloomingdale