Drywall Taping & Finishing in Warrenville, IL

Drywall finishing in Warrenville, matched to the light

Taping and finishing is the work between hung board and a wall ready to paint. Our crew tapes every seam, sets bead on outside corners and builds the joints up in three coats that we sand between. For most painted walls that is a level 4 finish, and it looks right under normal room light. When a wall will sit under strong side light or take a glossy paint, we add a level 5 skim, a thin coat over the entire surface, so paper and compound look the same once painted.

We work in Warrenville every week, coming in on I-88 and Route 59, with Butterfield and Winfield roads taking us across town. If your Warrenville house is getting an addition or a family room with tall windows, the light coming through them rakes along the walls at a low angle. That kind of light shows every seam that sits a hair proud of the board, and paint will not hide it. We plan for it before the first coat, deciding with you which walls get a skim and which are fine at level 4.

Drywall Taping & Finishing by ONIT Solutions

Finishing work we handle in Warrenville

Seam taping

Paper tape bedded tight on every tapered and butt joint, with no dry spots left behind it.

Corner bead

Metal or paper-faced bead on outside corners, set straight down the full height of the wall.

Level 4 finish

Three coats feathered wide and sanded, the right finish for walls that get flat or eggshell paint under normal light.

Level 5 skim

A thin coat over the whole wall for rooms with strong side light, tall windows or a paint with more sheen.

Butt joint feathering

Where two untapered board ends meet, we carry the compound out much wider so the joint does not read as a bump.

Ready for primer

Dust wiped down and each wall checked with a work light, so primer goes onto a clean, flat surface.

From estimate to final coat

Our estimate is written on site and lists each room, which walls get level 4 and which get a skim, and how many visits the drying will take. Anything that changes after that, like a wall you decide to skim after all, gets priced on paper and approved by you before we do it. Drying time between coats is built into the schedule, not squeezed out of it. On the last visit we light each wall from the side and go over it with you.

Written estimate before we start
Finish level chosen wall by wall
Level 5 skim where the light needs it
Butt joints feathered extra wide
Changes approved in writing first
Side-light check on the final visit

Drywall Taping & Finishing estimate in Warrenville

Tell us about the project and we will set a time to look at it.

FAQ

Drywall Taping & Finishing in Warrenville: questions

What is the difference between a level 4 and a level 5 finish?

Level 4 is taped seams, corners and fasteners covered in three coats and sanded. Level 5 adds a thin skim over the whole wall, so the paper and the joints take paint the same way under strong light.

Do I need level 5 in every room?

No. Most painted walls look right at level 4. We point out the walls where window light or a glossy paint would show the joints, and you decide.

Do you work near Warrenville?

We do. We also tape and finish drywall in Naperville, Wheaton and Lisle.

Will I need a permit in Warrenville?

The finishing usually rides on the permit for the larger job, such as an addition or a basement. We check with Warrenville before work starts and handle the permit when one is required.

How long does taping and finishing take?

Each coat has to dry before it is sanded, so most rooms take several visits spread over a few days, and a skim adds time. Call or text (815) 585-1750 and we will give you the visit schedule with the estimate.

Other work we do in Warrenville

Nearby

Drywall Taping & Finishing in Warrenville