Bolingbrook, Will County

Basement Finishing in Bolingbrook

Keep every inch of headroom the basement has, with ducts and beams boxed in clean and the water question settled first. We work in Bolingbrook every week.

Bolingbrook basement finishing that works with the ceiling you have

Before we talk ceilings, we check the walls and the slab for moisture and take care of any drainage or sump work, because nothing gets covered over a water problem. Then we frame with treated bottom plates, insulate the foundation walls, run the electrical and any plumbing for a bath or wet bar, and hang drywall. Ceilings, flooring, doors, trim and paint finish the rooms, and we pull the permits and handle the inspections. If you want the whole basement designed and built start to finish, that runs under our ONIT Restoration brand, the same company with a crew that does basements all day, and ONIT Solutions takes the partial finishes, single trades and fixes to a basement that is already finished.

We cover Bolingbrook from I-55 and Route 53, and reach the rest of town on Boughton Road, Weber Road and Veterans Parkway. In most basements the main duct trunk and a beam run down the middle, and how we box them decides how the room feels. We frame soffits tight to the duct, keep them in straight runs, and line up the lighting so the soffit reads as part of the plan. If your Bolingbrook house has a lower level that sits partly above grade, the window walls frame differently from the buried walls, and we price them separately.

Basement Finishing by ONIT Solutions

What a Bolingbrook basement finish includes

Water first

Walls, slab and sump are checked, and any drainage or pump work is finished before we frame.

Soffits and beam wraps

Ducts, beams and pipes are boxed in tight and straight, with access panels at dampers and valves.

Treated-plate walls

Bottom plates are pressure treated where they sit on concrete, and the walls hold the clearances the furnace and panel need.

Insulation

Foundation walls are insulated before drywall so the room stays comfortable year round.

Lighting and circuits

Recessed or surface lights are laid out around the soffits, and new outlets and circuits go in to code.

Drywall through paint

Drywall, ceilings, flooring, doors, trim and paint are all on the same estimate.

How we run a Bolingbrook basement

We measure ceiling heights at the ducts, the beam and the open bays, and check the walls for moisture on the same visit. The written estimate shows the soffit plan, the rough-in and the finishes line by line. If something behind the old ceiling changes the plan, you get the price in writing and decide before we do it. We set the start date with you and book our work around the inspection dates. Before we leave, we walk the finished basement with you and test every light and outlet.

  • Headroom measured before we design soffits
  • Sump and drainage sorted before framing
  • Access panels at every damper and valve
  • Village permit pulled and every inspection booked
  • Change orders in writing, approved by you
  • Final walkthrough with every light tested
Full basement design and build runs under our ONIT Restoration brand. Same company, a crew that does basements all day.
FAQ

Basement Finishing in Bolingbrook: questions

Will finishing the basement lower my ceiling?
It only drops where the ducts and beam already hang. We frame soffits tight around them and leave the open bays at full height, so the room keeps as much headroom as the structure allows.
Do I need a permit in Bolingbrook to finish a basement?
Finishing a basement in Bolingbrook generally needs a village permit, since it adds walls and wiring. We pull it and schedule the framing, rough-in and final inspections.
How long does a basement finish take?
It depends on the square footage, whether there is a bath, and when the inspections land. Your estimate comes with the order of work and the points where we wait for an inspector.
Do you finish basements in towns next to Bolingbrook?
Yes. We also work in Romeoville, Woodridge, Darien and Lemont.
How do I set up an estimate?
Call or text (815) 585-1750. We will come out, measure the ceiling and check the walls for moisture before we write anything up.

More questions and answers ›

Also in Bolingbrook

Other work we do in Bolingbrook

Nearby

Basement Finishing in nearby towns

Free estimate

Get a Bolingbrook basement plan that keeps your headroom

Send a text or call (815) 585-1750, and we will measure every duct and beam before a soffit gets drawn.

Call or text (815) 585-1750
Email matt@onitcc.com

Or call or text (815) 585-1750. We reply during business hours.

Call (815) 585-1750Get an Estimate