Paint Spraying in Homer Glen, IL

Paint spraying in Homer Glen

Homer Glen is on our regular route, and we bring an airless sprayer to the jobs where it gives a better coat than a roller: long fences, exterior siding, empty rooms and new drywall. Spraying lays the paint on evenly and gets into the grooves, gaps and edges a brush skips. Most of the work happens before the sprayer starts, because everything that is not getting paint gets covered. If your job would come out better with a brush and roller, we tell you that at the estimate.

We reach Homer Glen up I-355 and along 143rd and 159th Street, in Will County between Lockport, Lemont and New Lenox. If your property runs back on a big lot with a long fence line, spraying is often the only sensible way to coat both sides of every picket. Open ground also means wind, and wind carries paint mist farther than most people expect. We check the wind before we start, set up a shield on the downwind side, and stop when it picks up rather than finishing in a gust.

What spraying covers on a Homer Glen job

Fence boards, both faces

Each picket and rail gets coated front, back and on the edges, where a roller leaves bare wood.

Siding and trim

Lap siding gets paint under each course and into the joints, then trim is cut in by hand where it needs a sharp line.

Masking around the work

Windows, doors, light fixtures, hose bibs and anything else keeping its own color get papered and taped.

Ground and plantings covered

Drop cloths go over beds, patios and the driveway, and plants near the wall get wrapped.

Wind watched all day

We spray when the air is calm enough to keep mist on the surface and pause when it is not.

Back-rolling where it helps

On rough wood, a roller follows the sprayer to push paint into the grain.

How a Homer Glen spray job runs

We look at the fence or the house with you and leave a free written estimate that lists the surfaces, the masking, the product and the coats. If we find loose boards or rot once we start, the fix is priced in writing and nothing happens until you approve it. Spray days are set by the forecast, and we book around the days we said. At the end we pull the masking, check every edge with you, and leave the yard the way we found it.

Free written estimate
Full masking before spraying
Spraying only in calm wind
Back-rolling on rough wood
Plants and drive covered
Final walk of every edge

Paint Spraying estimate in Homer Glen

Tell us about the project and we will set a time to look at it.

FAQ

Paint Spraying in Homer Glen: questions

Do you spray fences and houses near Homer Glen?

Yes. We spray in Lockport, Mokena and Orland Park too, with the same masking, the same wind rules and a written estimate up front.

Is spraying better than rolling for a fence?

For most picket and board fences, yes, because the sprayer reaches the gaps and edges a roller misses. A short run of solid fence can come out just as well by roller, and if that is your fence we will say so.

When can you spray outside?

Exterior spraying runs spring to fall on dry days above 50 degrees, and only when the wind is calm enough. Call or text (815) 585-1750 to get on the estimate schedule.

Does painting a fence in Homer Glen need a permit?

A repaint usually does not. If the job grows into rebuilding fence sections or siding, we check what the village requires and pull any permit before that work starts.

Are you insured?

Yes. We carry liability insurance and can send the certificate before we start.

Paint Spraying in Homer Glen