Mold Remediation in Montgomery

Mold remediation in Montgomery homes

A mold job is only finished when the water that caused it is stopped. We seal the work area with plastic, put it under negative air and run HEPA air scrubbers while drywall, insulation and other affected material come out. Studs, sheathing and surfaces that stay are cleaned and treated with antimicrobial. Then we repair the leak and rebuild the wall.

Montgomery is on our regular route, by Route 30, Route 31 and Orchard Road, on both the Kane and Kendall County sides. Mold on an exterior wall inside the house can come from outside, through a gap at a window, a failed caulk joint or damaged siding and trim. If your Montgomery house has a stain under a window or at the bottom of an outside wall, we open the wall to see how much water the sheathing took on. We fix the siding, trim and caulk outside, so the rebuild inside stays dry.

Montgomery mold remediation, inside and out

How a Montgomery mold job is run

We look at the stain inside and the wall outside, then write you an estimate that covers both. If the wall is wetter or the damage wider than the estimate assumed, we price the extra work in writing and only do it once you approve. We recommend an independent tester check the area after cleaning, then we close the wall and finish the outside repair on the days we booked. A walkthrough inside and out ends the job.

• Estimate covering inside and outside
• Room sealed before the wall opens
• Sheathing and studs cleaned and treated
• Siding, trim and caulk repaired
• Independent clearance check advised before the wall closes
• Walkthrough inside and out