New walls and ceilings in your Westmont home with no hump where the sheets meet and no rough ring around the lights. We tape and finish the board until the joints are gone under the paint.
Drywall sheets come with tapered long edges so the tape sits low, but the short ends are full thickness. Where two ends meet, the butt joint has nowhere to hide the tape, so a narrow finish leaves a hump you can see from across the room. We feather those joints much wider than a tapered seam, often two feet or more, so the build-up spreads out and disappears. The rest of the board gets paper tape, corner bead, three sanded coats and a coat of primer.
We work in Westmont every week, in DuPage County along Ogden Avenue, Route 83, Cass Avenue and 55th Street. If your Westmont remodel adds recessed lights, they throw light across the ceiling right where the joints are. When we hang the board too, we lay it out so butt joints land away from the fixtures where we can, and we clean up every cutout so the trim rings sit flat. That is the difference between a ceiling that looks finished at night and one that shows every pass of the knife.

End joints spread two feet or more so no hump shows.
Long edges taped in paper and filled flat with three coats.
Edges around cans, boxes and vents cleaned up so trim rings and covers sit flat.
Overhead joints coated thin and wide, then checked with a light at a low angle.
Outside corners beaded and coated straight from floor to ceiling.
The whole surface primed so the joints do not show as dull patches in the paint.
You get a free written estimate after we see the board, and it lists the rooms, the ceilings and the finish level we plan for each. If we find a joint that will not finish well, like a butt joint landing on a crooked joist, we explain it, price the fix in writing and wait for you to approve it. Each coat dries before the next, so the work spreads over several visits, and we book around the days we said. At the walkthrough we turn on the new lights and look at the ceiling with you.
Call or text (815) 585-1750. We will look at the board and the lighting plan and give you a written scope.
Call or text (815) 585-1750
Email matt@onitcc.com