Drywall & Framing in Aurora, IL

Drywall and framing in Aurora, built to code

Drywall is not one product. Bathrooms and laundry rooms get moisture-resistant board, and the wall and ceiling between an attached garage and the house get fire-rated board where code calls for it, with every seam taped. We frame partitions, closets and bulkheads, close or cut openings, and repair framing damaged by water or impact. Then we hang, tape and finish everything to a surface ready for paint.

We cover Aurora on both sides of the Fox River, using I-88, Route 59, Eola Road, Orchard Road and Farnsworth Avenue to get around. The city reaches into Kane, DuPage, Will and Kendall counties, but building permits run through the City of Aurora wherever the house sits. Garage conversions and rooms over the garage are where fire-rated board matters most, and an inspector will look for it on the shared wall and ceiling. Garage drywall also takes hits from car doors and stored equipment, and repairs there should go back with rated board, not whatever was left over.

Aurora drywall and framing, board by board

Fire-rated garage walls

Rated board on the wall and ceiling shared with the house where code calls for it, with every seam taped.

Moisture-resistant board

Bathrooms, laundry rooms and other wet areas get board made for humidity.

Partitions and closets

New walls and closets framed straight with headers at every opening.

Openings closed or cut

We close old doorways flush or cut new ones with a header sized for the span.

Framing repair

Studs and plates damaged by water or impact are replaced or sistered before new board goes up.

Finish ready for paint

Hung, taped, sanded and cleaned up so the room is ready for primer.

How an Aurora drywall project runs

We walk the space, note where code requires rated or moisture-resistant board, and put that into a written scope with the framing and finish work. If the job needs a permit, the scope says so and we handle it. You approve the price before we start, and anything we find inside a wall gets priced in writing for your approval. We schedule the work on set dates and finish with a walkthrough.

Fire-rated board where code calls for it
Humidity-rated board in baths and laundry
Permit and inspections handled when required
Written price approved before work
Floors and doorways protected
Walkthrough at the finish

Drywall & Framing estimate in Aurora

Tell us about the project and we will set a time to look at it.

FAQ

Drywall & Framing in Aurora: questions

Does my garage wall need fire-rated drywall?

On an attached garage, the wall and ceiling shared with the living space generally need rated board, and a room over the garage makes it even more important. We confirm the requirement for your house and use rated board wherever code calls for it.

Do I need a permit for drywall and framing in Aurora?

Patching and replacing drywall usually does not. Structural changes, garage conversions and walls with new electrical or plumbing generally do, and we pull the permit through the City of Aurora when it is required.

How soon can you start?

Repairs can be same-day when the schedule allows. Framing and finishing jobs are booked on set days after you approve the estimate. Call or text (815) 585-1750 to set up the visit.

Which towns near Aurora do you cover?

We also work in Montgomery, Oswego, Warrenville and Naperville.

Are you insured?

Yes. We carry liability insurance and can send you the certificate before we start.

Other work we do in Aurora

Nearby

Drywall & Framing in Aurora