Paint Spraying in Rosemont

Paint spraying in Rosemont, kept inside the work area

Spraying puts fine paint mist in the air, so controlling it is half the job. We tape plastic over every door and opening out of the work area, cover the floors, windows, fixtures and outlets, and close off the vents so mist does not get pulled through the ductwork. Then we spray ceilings, walls, doors and trim, back-rolling the walls where it helps the finish. If a space cannot be sealed well enough, we roll it instead and tell you why.

We cover Rosemont, reaching it off I-90, I-294, River Road and Balmoral Avenue. If you live in a Rosemont condo or a townhome with shared walls and hallways, the building may have rules about work hours, elevator use and common areas, and we work from those rules. We seal your entry door from the inside, so nothing drifts into a shared hall. Exterior work on an attached home usually needs association approval, and we can give the association the scope in writing.

What we cover on a Rosemont spray job

How a Rosemont spray job runs

We look at the rooms, ask about any building or association rules and write an estimate that lists each surface, the masking and the coats. Anything that changes once we start, like wall damage behind a piece of furniture, gets priced in writing for your approval before we touch it. We schedule inside the building's allowed work hours where those apply. At the end, the masking comes down, the rooms get cleaned and we walk them with you.

• A written estimate with the masking spelled out
• Building or association rules followed
• Work area sealed from the rest of the home
• Vents covered while we spray
• Shared hallways protected and cleaned
• A final walkthrough with you