Oak Brook, DuPage County

Mold Remediation in Oak Brook

Our phone at (815) 585-1750 is answered 24/7, so call or text about mold in your Oak Brook home. You get the area contained and cleaned, the moisture stopped and the room rebuilt by one company.

Mold remediation for Oak Brook homes, start to finish

Mold remediation means taking out what the mold grew into and cleaning what can stay, without sending it through the rest of the house. That is what containment, negative air and HEPA air scrubbing are for, and they go up first. After removal, we clean the framing and hard surfaces, apply antimicrobial and dry anything that is still wet. The last step before the rebuild is making sure the moisture that started it is fixed.

We cover Oak Brook, coming in on I-88 and I-294 or along Route 83, York Road and 22nd Street in DuPage County. If your house has a large finished lower level, the mechanical room is worth a look, since a condensate line from the air conditioner or a leaking drain nearby can wet the bottom of a wall for months before anyone notices. We trace the stain back to where the water comes from. Where it is a plumbing leak, we repair it, and where it is outside our trades, we tell you plainly what it is so it gets fixed before the wall closes.

Mold Remediation by ONIT Solutions

What we do on an Oak Brook mold job

Containment first

The affected area is closed off with plastic sheeting and a sealed doorway before we touch anything.

Negative air to the outside

A negative air machine exhausts the air from inside the containment to the outdoors.

HEPA filtration

HEPA air scrubbers keep filtering the air while materials are cut out and surfaces are cleaned.

Material removal

Anything with growth in it, from drywall and insulation to carpet pad and lower cabinets, is cut out and bagged inside the containment.

Antimicrobial treatment

Framing, subfloor and other surfaces that stay are cleaned and treated with antimicrobial.

Drying and the rebuild

Wet framing is dried and read until it shows dry, then insulation, drywall, trim, flooring and paint go back.

The Oak Brook job, in order

First comes a look at the area and a written estimate, before we start. The scope covers containment, removal, cleaning, the moisture fix and the rebuild, and daily rates for any drying equipment are in writing before it is set up. You approve any change in writing, including more growth found once a wall is open. When the cleaning is done we recommend an independent tester confirm clearance, then we rebuild and walk through it with you.

  • Answered 24/7 by call or text
  • Containment and negative air
  • HEPA air scrubbing
  • Line-by-line estimate
  • Moisture source traced
  • Final walkthrough after the rebuild
FAQ

Mold Remediation in Oak Brook: questions

Do you test for mold?
No. ONIT Solutions does not do mold testing. If you want to know what is growing before we start, or want proof it is gone after, hire an independent tester. We recommend one for clearance either way, so the check is done by someone with no stake in the work.
What should I do before you get there?
Leave it alone. Do not scrub it, sand it or point a fan at it, because that moves it around. Close the door to the room if there is one, and if water is still coming in, shut off the supply if you can reach it. Then call or text (815) 585-1750 with a photo.
Does Oak Brook require a permit for this?
The remediation itself usually does not. Rebuild work that touches framing, electrical or plumbing can, and we handle the permit with the Village of Oak Brook where they require one.
How long does it take?
Setup and removal come first, and the length depends on how much material is affected. Then the area dries, gets cleaned and treated, and waits for clearance. The rebuild follows on dates we set with you, and we book around the days we said.
Do you cover towns around Oak Brook?
Yes. We take mold work in Oakbrook Terrace, Elmhurst, Hinsdale and Westmont as well.

More questions and answers ›

Also in Oak Brook

Other work we do in Oak Brook

Nearby

Mold Remediation in nearby towns

Free estimate

Seeing mold in Oak Brook?

Send us a photo at (815) 585-1750, any hour. We will tell you what we would contain and what we think is causing it.

Call or text (815) 585-1750
Email matt@onitcc.com

Or call or text (815) 585-1750. We reply during business hours.

Call (815) 585-1750Get an Estimate