Mold Remediation in Aurora, IL

Aurora mold remediation, in all four counties

When you call about mold, we come out, find the moisture and write up what has to go. The work area is sealed with plastic and kept under negative air, with HEPA air scrubbers filtering the space the entire time. We cut out drywall, subfloor, flooring and insulation the mold has reached, then clean and treat the framing with antimicrobial. The leak gets repaired, and we rebuild the room.

We work in Aurora every week, on I-88, Route 59, Orchard Road, Eola Road and Farnsworth Avenue, on the Kane, DuPage, Will and Kendall county sides alike. A toilet with a failed wax ring can leak a little with every flush, and the subfloor around it can grow mold underneath while the floor on top still looks fine. If your Aurora bathroom floor feels soft near the toilet, we pull the toilet, read the subfloor and cut out what is lost. The new subfloor, flooring and a properly set toilet go back in after the framing is cleaned and treated.

What mold remediation covers in Aurora

Containment

The bathroom or room is sealed with plastic, and the doorway gets a sealed entry.

Negative air

We set a negative air machine so the air in the work area moves out, not into the hallway.

HEPA air scrubbing

HEPA scrubbers run through demolition and cleaning to filter the air in the space.

Subfloor and flooring removal

Moldy subfloor, underlayment, flooring and drywall come out and leave the house bagged.

Framing cleaned and treated

Joists and studs that stay get cleaned and treated with antimicrobial before anything closes up.

Toilet reset and rebuild

A new wax ring and a properly set toilet go back on new subfloor and flooring.

How an Aurora mold job runs

You get a free estimate in writing, with the removal, cleaning, repair and rebuild each listed. If we lift the floor and the mold runs past what we expected, we price that work in writing and wait for your approval. After cleaning, we recommend an independent tester confirm the area before the new floor goes down. Then we schedule the rebuild and finish with a walkthrough.

Free written estimate
Sealed bathroom or room
Negative air and HEPA filtration
Leak repaired before the rebuild
Clearance check by an independent tester advised
New subfloor and finishes, walked with you

Mold Remediation estimate in Aurora

Tell us about the project and we will set a time to look at it.

FAQ

Mold Remediation in Aurora: questions

Do you test for mold?

No, we do not test for mold. We recommend an independent tester confirm the area after we clean it and before new material goes in, so the result comes from outside the job.

Do I need a permit in Aurora?

The City of Aurora handles building permits inside the city no matter which county your house is in. Removal and cleaning usually do not need one, and when the rebuild includes plumbing, electrical or framing, we pull the permit and schedule inspections where Aurora requires them.

How long does a bathroom floor take?

Removal and cleaning usually take a few days. The rebuild follows the clearance check, and your written estimate shows the schedule.

Is mold covered by insurance?

That depends on your policy and on what caused the water, so ask your carrier. If you open a claim, we write the estimate in the format carriers use and can meet the adjuster at the house. Call or text (815) 585-1750 and we can start with the photos and readings.

Do you work near Aurora?

Yes. We handle mold remediation in Montgomery, Oswego, Naperville and Warrenville too.

Mold Remediation in Aurora