Flooring Installation in Hinsdale, IL

Flooring installation in Hinsdale, built on a fixed subfloor

We install luxury vinyl plank, tile, laminate and engineered hardwood, plus stair treads, risers and nosing. The part of the job you never see matters most: the subfloor has to meet the product's flatness spec, and most do not until we level the low areas, patch the damaged ones and sand down the high joints. We also screw down loose sheathing so a squeak does not come back under the new floor. Base, shoe and transitions are part of every install.

We come into Hinsdale on I-294 and work along Ogden Avenue, York Road and County Line Road, through downtown and around the Metra station in DuPage County. Where an older house has a board subfloor instead of plywood, the boards can cup, shrink and leave gaps that telegraph through a thin floor. We may add a layer of plywood over the boards, fasten it on a tight pattern, and then check flatness again. If a floor dips in the middle of a room, we look underneath before we cover it, since a sagging joist needs a fix from below, not more leveling compound on top.

What a Hinsdale flooring job includes

Squeak repair

We find the loose spots, screw the sheathing to the joists and stop the squeak before it gets buried.

Plywood over board subfloors

If the subfloor is old boards, we add plywood fastened on a tight pattern so the new floor has a flat base.

Joist checks from below

A dip in the middle of a room gets a look from the basement before we decide how to fix it.

Leveling and patching

Remaining low spots get filled, and high joints get sanded to the product's tolerance.

Doors cut to clear the new height

Plywood plus new flooring raises the floor, so we trim door bottoms and undercut jambs to keep every door swinging.

Rooms protected while we work

We cover the rooms and paths we are not working in and leave each room cleaner than we found it.

How a Hinsdale floor job runs

At the free estimate, we walk the floors listening for squeaks, check flatness, and look at the joists from the basement where we can. You get a written scope that names the product, the subfloor work and the trim. If the tear-out shows a cut joist or old water damage, we price the fix in writing and wait for your approval before going further. When the floor is in, we walk it with you and listen for squeaks together.

Squeaks fixed before the new floor goes down
Plywood added over board subfloors when needed
Joists checked from below on any dip
Doors trimmed to clear the new height
Structural repairs priced before work
A final walk listening for squeaks

Flooring Installation estimate in Hinsdale

Tell us about the project and we will set a time to look at it.

FAQ

Flooring Installation in Hinsdale: questions

My floor squeaks. Will a new floor fix it?

Not by itself. A squeak comes from loose subfloor rubbing on a nail or joist, and covering it only buries the noise. We screw the subfloor down first so the new floor goes on quiet.

Do I need a permit in Hinsdale for new flooring?

A floor covering replacement generally does not need one. Joist repair or structural changes can, and we check with the village and pull the permit where it is required.

Do you cover towns around Hinsdale?

Yes. Clarendon Hills, Western Springs, Oak Brook and Burr Ridge are on the same route.

How much time does subfloor work add?

Screwing down and sanding usually fits inside the install days. Adding plywood over boards or fixing a joist adds a day or more, and we put that in writing at the estimate.

How do I get started?

Call or text (815) 585-1750 and we will come walk the floors and check the subfloor.

Other work we do in Hinsdale

Nearby

Flooring Installation in Hinsdale