Call or text (815) 585-1750, 24/7, if you have found mold in your Minooka house. We remove it under containment, stop the leak behind it, and rebuild the cabinets, walls or floors it damaged.
Our mold work follows the same order every time, because the order is what keeps it from spreading. Containment goes up first, with negative air pulling from the work area and a HEPA air scrubber filtering the air inside it. Next, the materials the mold has damaged are removed and bagged, and the surfaces that remain are cleaned and treated with an antimicrobial. Last, we fix the moisture that started it and rebuild.
We work in Minooka every week, reaching it on I-80 and Route 6 and getting around town on Ridge Road and McLindon Road. Minooka crosses Grundy, Kendall and Will counties, so before rebuild work that needs a permit, we confirm what applies to your address. If the mold is inside a kitchen sink base or behind the dishwasher, the cause is often a slow drip from a supply line, a drain joint or the dishwasher hose that nobody could see. We fix the plumbing, take out the damaged cabinet floor and the wet drywall behind it, treat what is left, and put in a new base cabinet or panel that fits the run.
Even at a kitchen sink, we seal the area with plastic so the rest of the kitchen and the house stay clean.
Air from the work area is pulled out by a negative air machine and filtered by HEPA scrubbers during removal.
A swollen cabinet floor, wet drywall and stained insulation are removed and bagged, not painted over.
Studs, the subfloor and nearby cabinet sides are cleaned and treated with an antimicrobial before the rebuild.
We replace the failed supply line, drain joint or hose that let the water out, and confirm the area stays dry.
We put in new drywall and a replacement base cabinet or cabinet floor, then do the finish work so the kitchen looks the way it did.
We start with a free on-site estimate that spells out the removal, the treatment, the repair and the rebuild. You see the daily rate for each air machine in writing before it is plugged in, and any added work found once things are opened up is priced and approved by you first. We recommend an independent tester confirm clearance after cleaning, then we schedule the rebuild. When it is finished, we go over the kitchen or room with you.
Open the sink cabinet, take a picture, and text it to (815) 585-1750. Or call, any hour.
Call or text (815) 585-1750
Email matt@onitcc.com