Fire & Smoke Damage Restoration in Channahon, IL

Fire damage restoration for Channahon homes

A house fire leaves three kinds of damage: what burned, what the smoke reached, and what the fire hoses soaked. We handle all three. Burned and soaked materials come out, soot gets cleaned off the walls, ceilings and surfaces that can be saved, and air movers and dehumidifiers dry the rest while HEPA scrubbers clean the air. Once the house reads dry, we rebuild it.

Channahon is off I-55 and I-80 for us, and Route 6 takes us through town between the Des Plaines and DuPage rivers. It is a Will County village, with the I&M Canal and Channahon State Park inside it. If your house has a basement, water used on a first-floor fire can run down through the floor and collect there. That is why we take moisture readings below the fire room as well as in it.

Fire & Smoke Damage Restoration by ONIT Solutions

What we take care of after a Channahon fire

Damaged materials removed

We cut out burned drywall and pull charred insulation, flooring and trim, then haul the debris off the property.

Soot cleaned from surfaces

Ceilings, walls, doors and cabinets that came through the fire get cleaned rather than torn out when cleaning will do it.

Clean air while we work

HEPA air scrubbers filter soot and dust out of the air through the tear-out and cleaning.

Smell removed, not masked

The odor comes out with the materials that absorbed it, and the framing left behind is sealed before new drywall goes up.

Hose water extracted and dried

We extract the standing water, open wet walls with flood cuts where needed, and run drying equipment until the readings say dry.

Rooms rebuilt

Drywall, insulation, flooring, cabinets, trim and paint are put back by ONIT Solutions from a scope written while the drying runs.

What working with us looks like in Channahon

The first visit is a walkthrough where we photograph the damage and take moisture readings, and you get copies of both. From there we write an itemized estimate in the format insurance carriers use, and we can be at the house when your adjuster comes. Daily equipment rates are in writing before setup, each machine gets checked every day, and it comes out once its area reads dry. We book the rebuild around the days we said, and we walk it with you at the end.

Photos and moisture readings, copied to you
An itemized, carrier-format estimate
Equipment checked every day
Machines pulled once readings say dry
Rebuild work booked on the days we said
A walkthrough when the rooms are done

Fire & Smoke Damage Restoration estimate in Channahon

Tell us about the project and we will set a time to look at it.

FAQ

Fire & Smoke Damage Restoration in Channahon: questions

We just had a fire. What should we do first?

Wait for the fire department to clear the house before anyone goes back in. Leave the soot alone, since wiping it pushes it into paint and fabric and makes it harder to clean. Take pictures of every room and the damaged contents, and call your insurance company to start the claim.

Do you work in towns around Channahon?

We do. Minooka, Shorewood and Joliet are all on our route for fire and smoke damage.

Who issues the permit for a fire rebuild in Channahon?

A house inside the village goes through the village, and an unincorporated address goes through Will County. We pull the permit where one is required and schedule the inspections.

When can you start?

Call or text (815) 585-1750 at any time. We answer around the clock and dispatch as soon as we can, and the schedule for drying and the rebuild goes in writing with your estimate.

Why can't we just paint over the smoke stains?

Paint alone does not hold back smoke stains or the smell. We clean the soot first, seal what needs sealing, and paint after that.

Other work we do in Channahon

Nearby

Fire & Smoke Damage Restoration in Channahon