Glendale Heights, DuPage County

Drywall Taping & Finishing in Glendale Heights

Seams that show through the paint, tape that bubbled, corners that cracked: we re-finish bad drywall work in Glendale Heights so the walls finally look done.

Re-finishing bad drywall seams in Glendale Heights

Not every taping job comes out right. A wall can show ridges along every seam, tape that bubbled or lifted, butt joints that bulge, or inside corners that cracked within a season. We cut out tape that has let go, re-bed it, and then build the seams back up with three coats feathered wide and sanded between each. Where the whole wall is rough, a skim coat over the entire surface brings it back to one plane.

Glendale Heights is on our regular route, along North Avenue, Army Trail Road, Bloomingdale Road and Glen Ellyn Road, and we cover the DuPage County towns around it from Carol Stream to Addison. If you bought a house with a finished basement or a remodeled room that someone else taped, problems like these often show up after the first coat of paint or the first winter. We find the cause first, whether it is tape bedded dry, mesh used with the wrong compound or seams sanded through, so the fix holds instead of repeating the mistake. Then we prime and leave the walls ready for paint.

Drywall Taping & Finishing by ONIT Solutions

What re-finishing covers in Glendale Heights

Bubbled tape cut out

Tape that lifted or blistered cut away and re-bedded in fresh compound.

Ridged seams flattened

High seams sanded down and re-coated wider so they stop casting a shadow.

Bulging butt joints

End joints feathered out across a wider area until the bump is gone.

Cracked corners re-taped

Inside corners opened, re-taped with paper and finished straight.

Full skim where needed

A skim coat over a whole wall when spot fixes would leave it patchy.

Primed for paint

Re-finished areas primed so the new paint goes on even.

How re-finishing a Glendale Heights wall works

We come out, look at the seams in good light and leave a free written estimate that lists each wall and whether it gets spot repairs or a full skim. If we open a seam and find a bigger problem, like loose board or moisture behind it, we stop, price the fix in writing and wait for your approval. Each coat dries before the next, so the job runs across a few visits, and we book around the days we said. We finish with a walkthrough of every wall under a work light.

  • Written estimate listing every wall
  • Lifted tape cut out and re-bedded
  • Ridges and bulges flattened
  • Cracked inside corners redone
  • Full skim where spot fixes would show
  • Work-light walkthrough at the end
FAQ

Drywall Taping & Finishing in Glendale Heights: questions

Why are my drywall seams showing through the paint?
Usually the seams were left high, the coats were not feathered wide enough, or the wall went without primer before paint. We look at it under a low-angle light to see which one it is before we write the estimate.
Do I need a permit in Glendale Heights to re-finish seams?
No permit is usually needed to re-tape and re-coat existing drywall. If the work turns up a wiring or framing issue, we check with the Village of Glendale Heights and pull what it requires.
Can you fix just the bad seams?
In many rooms, yes. When the problems are spread across a whole wall, a full skim coat gives a more even result than dozens of spot repairs, and we tell you which one we recommend.
How long does re-finishing take?
A few visits for most rooms, since each coat dries before the next goes on. A full skim adds another day or two.
Do you work in towns near Glendale Heights?
Yes. Glen Ellyn, Bloomingdale, Carol Stream and Lombard are on the same route. Call or text (815) 585-1750 with photos of the seams.

More questions and answers ›

Also in Glendale Heights

Other work we do in Glendale Heights

Nearby

Drywall Taping & Finishing in nearby towns

Free estimate

Fix the seams in your Glendale Heights walls

Show us the worst wall first. Text a photo to (815) 585-1750 or call, and we will look at it in good light and write up the fix.

Call or text (815) 585-1750
Email matt@onitcc.com

Or call or text (815) 585-1750. We reply during business hours.

Call (815) 585-1750Get an Estimate