Drywall & Framing in Elmhurst, IL

Garage drywall and framing in Elmhurst

The wall and ceiling between an attached garage and the house are a fire separation, and code calls for gypsum board there, with heavier fire-rated board on a ceiling that has a bedroom over it. When those surfaces get damaged, cut open for an opener or a new circuit, or were never finished, we hang the right board, tape every joint and seal the gaps so the separation does its job. The door from the garage into the house is part of that separation too, and we can frame and set the right door. Everything is written up and priced before we start.

We work in Elmhurst from I-290 and I-294, with York Road, North Avenue and St. Charles Road carrying the crew through the city, downtown and the area around Elmhurst University. It is a DuPage County city that borders Villa Park, Oak Brook and Addison. A garage that doubles as a workshop or a gym needs walls that can hold shelving and cabinets, not just board. When we hang the drywall, we add blocking where the cabinets will go so they anchor into solid wood.

Garage and interior framing in Elmhurst

Fire-rated garage walls

The wall shared with the house gets the board code calls for, taped and finished so the separation is complete.

Garage ceilings under bedrooms

Where living space sits above, the ceiling goes up in the heavier fire-rated board code requires.

Openings patched to match

Holes cut for openers, wiring or vents are closed with matching board, not a scrap patch.

Blocking for cabinets and shelving

We add wood blocking where garage cabinets, shelves or a pegboard wall will hang.

New partitions inside the house

Closets, room dividers and partition walls are framed and finished alongside the garage work.

Finish level to suit the room

Garage walls get taped and coated for paint, and living spaces get a smooth finish ready for a painted wall.

How a garage drywall job runs

We look at the garage, check what the wall and ceiling are made of now and write a scope that names the board type and the finish level. Anything behind the surface that needs attention, like an open duct penetration or damaged framing, gets priced in writing for your approval first. We clear a working area, cover the floor, and schedule the days so your cars are out of the garage for as little time as the work takes. At the end we walk it with you and sweep out.

Written estimate naming the board type
Fire-rated board where code calls for it
The right door to the house if needed
Blocking for garage cabinets
Permits and inspections where required
Garage swept and cleaned at the end

Drywall & Framing estimate in Elmhurst

Tell us about the project and we will set a time to look at it.

FAQ

Drywall & Framing in Elmhurst: questions

Does my garage need fire-rated drywall?

The wall and ceiling between an attached garage and the house have to separate the two, and drywall is how code does it. A garage ceiling with a bedroom above it calls for heavier fire-rated board.

Do I need a permit to drywall my garage in Elmhurst?

Finishing the existing walls may not need one, but adding circuits, changing the door to the house or framing new walls typically does. We check with the city for your scope and pull the permit where it is required.

How long will my garage be out of use?

Hanging and finishing run over several days, since each coat of compound needs to dry before the next. We tell you ahead of time which days the cars need to stay out.

Can you hang cabinets on the new garage walls?

Yes. We add blocking where the cabinets will go before the board goes up, so they fasten into solid wood.

Do you work outside Elmhurst?

We do. Villa Park, Oak Brook, Addison and Lombard are all on our route. Call or text (815) 585-1750 from any of them.

Other work we do in Elmhurst

Nearby

Drywall & Framing in Elmhurst