Mold Remediation in Channahon, IL

Getting mold out of Channahon homes

When we take on mold, the first job is keeping it where it is. The work area gets closed in with plastic, a negative air machine keeps air moving out of that space instead of into the hallway, and HEPA scrubbers clean the air as we go. Whatever the mold has gotten into, from ceiling drywall to insulation, is removed and bagged, and the surfaces that stay are cleaned and given an antimicrobial treatment. After that we deal with the water problem behind it and rebuild the room.

We cover Channahon off I-55 and I-80, with Route 6 running through town between the Des Plaines and DuPage rivers in Will County. If the mold you are looking at is on a bathroom ceiling, check where the exhaust fan goes, because a fan that dumps into the attic, or a bathroom with no fan at all, leaves shower steam in the drywall every day. We cut out the stained ceiling, treat the framing above it, and install a fan ducted to the outside before the new drywall goes up. That way the paint stays clean instead of spotting again.

Mold remediation work we do in Channahon

Sealed-off work area

We close the bathroom or room in with plastic and keep the doorway sealed, so dust from removal does not travel down the hall.

Air pulled out, not pushed around

A negative air machine draws air from the work area to the outside while HEPA scrubbers filter what is inside.

Ceiling and wall removal

Drywall and insulation the mold has grown into are cut out past the edge of the growth and bagged before they leave the room.

Framing cleaned and treated

Joists, studs and sheathing that stay get cleaned and treated with an antimicrobial before anything covers them again.

Bath fan vented outside

If steam caused it, we install a properly sized exhaust fan ducted outside so the moisture leaves the house.

Drywall, paint and trim back

New moisture-resistant board goes up, then tape, primer, paint and any trim, so the bathroom is finished, not patched.

How we run mold work in Channahon

Every job starts with a free estimate on site, written so you can see each step and its cost. If removal turns up more than the estimate covered, the extra is written up and you approve it before we do it. We book the work on the days we said, run the air equipment at the daily rates you saw in writing, and suggest an independent clearance test before the rebuild starts. At the end we walk through the finished room together.

Free on-site estimate, in writing
Plastic containment and negative air
HEPA air scrubbers running throughout
Antimicrobial treatment on what stays
The steam or leak problem corrected
A finished room, not a patch

Mold Remediation estimate in Channahon

Tell us about the project and we will set a time to look at it.

FAQ

Mold Remediation in Channahon: questions

Do you test for mold?

We do not. We remove it, and we recommend you hire an independent tester to confirm the area is clear after cleaning. Keeping the test separate from the company doing the work is the honest way to run it.

Do you work outside Channahon too?

Yes. Minooka, Shorewood and Joliet are all part of our mold remediation work, along with Channahon.

Is a new bath fan part of the job?

It can be, and it should be if steam is what caused the mold. We price the fan and the duct to the outside as their own line on the estimate, so you can see them.

Will I need a permit?

Mold removal and cleaning do not usually need one. Rebuild work that adds a fan circuit or changes framing might, and we check with the village and pull it where it is required.

How soon can you start?

Call or text (815) 585-1750 any time and we get out for the estimate as fast as we can. Once you approve it, we book the removal and the rebuild on dates we put in writing.

Mold Remediation in Channahon